Maintenance; Assistance Programme; Preparation; Maintenance Table - Stiga Villa 2WD Serie Uso Y Mantenimiento

EN
• Cut grass frequently.
• Run the machine at full revs.
• Grass should not be wet.
• Only use sharp cutting devices.
• Keep the bottom side of the cutting device
clean.

9 MAINTENANCE

9 1

ASSISTANCE PROGRAMME

To keep the machine in good working order in
terms of reliability, safety and environmental pro-
tection, always adhere to the STIGA SpA servicing
programme.
The points of intervention for this programme are
illustrated in the attached STIGA SpA maintenan-
ce manual.
The Basic Service must always be carried out by
an authorized service workshop.
The First Service and Intermediate Service should
be carried out by an authorized service workshop,
but can also be carried out by the user.
The procedures are indicated in the handbook and
are described in the chapter "7 START-UP AND
OPERATION" as well as here below.
The checks carried out by an authorized service
workshop guarantee professional workmanship
and the use of genuine spare parts.
The handbook is stamped every time a Basic Ser-
vice is performed and each time an Intermediate
Service is carried out by an authorized service
workshop. A handbook with these stamps increa-
ses the second-hand value of the machine.
9 2

PREPARATION

All service and all maintenance checks
must be carried out on a stationary ma-
chine with the engine switched off.
Always apply the parking brake to stop
the machine from moving
Stop the engine
Prevent inadvertent start-up of the en-
gine by disconnecting the spark plug
cables and removing the ignition key
18
ENGLISH
(Translation of the Original Instructions)
9 3

MAINTENANCE TABLE

See chapter "13 MAINTENANCE SUM-
MARY TABLE" The table is designed to
help you keep your machine in efficient
and safe working order It indicates the
main operations to be performed and
the frequency of the same Perform the
relative operation described based on
the first deadline to arrive.
Change the oil more frequently if the
engine has to work in difficult condi-
tions or when the ambient temperature
is high
9 4

TYRE PRESSURE

Adjust the tyre pressure to meet the values provi-
ded in "0 TECHNICAL DATA TABLE".
9 5

ENGINE OIL TOP-UP/CHANGE

For this maintenance operation, see
also the manual for the engine supplied
with the machine

9 5 1 Inspection / top-up (18; 19; 19A)

Always check the fluid level before use.
To check the level, make sure the ma-
chine is on even ground
Wipe around the dipstick. Unscrew it and
pull it out. Wipe the dipstick clean.
(18; 19) Push the dipstick down comple-
tely and screw in place.
Now unscrew and pull the dipstick up
again. Read off the oil level.
(19A) Insert the dipstick completely without
screwing it in place.
Now pull the dipstick up again. Read off the
oil level.
Top up if the level is lower than the "FULL"
mark (18; 19; 19A).
The oil level must never exceed the
"FULL" mark This results in the engine
overheating If the oil level exceeds the
"FULL" mark, the oil must be drained
until the correct level is achieved
Change the oil more frequently if the engine has
to work in difficult conditions or when the ambient
temperature is high.