Cleaning / Replacement - Mod.: [Ggp] (18); Replace The Spark Plug; Cleaning The Air Intake; Lubrication (20) - Stiga Villa 2WD Serie Uso Y Mantenimiento

(Translation of the Original Instructions)
3 Remove the paper filter (19:B). Make sure
that no dirt gets into the carburettor. Clean
the air filter housing.
4 Clean the paper filter by tapping it gently
against a flat surface. If the filter is very dirty,
replace it.
5 Assemble the filter by performing the above
instructions in reverse order.
Compressed air or petroleum-based solvents
such as kerosene must not be used for cleaning
the paper filter insert. This will damage the filter.
The paper filter insert must not be oiled.
9 10 2 Cleaning / Replacement - mod :
[GGP] (18)
Remove/install the air filters as follows:
1 Carefully clean around the air filter cover.
2 Remove the air filter cover (18:A) by remo-
ving the two clamps.
3 Dismantle the filter assembly (18:D; 18:E).
The prefilter is placed over the air filter. Make
sure that no dirt gets into the carburettor.
Clean the air filter housing.
4 Clean the paper filter by tapping it gently
against a flat surface. If the filter is very dirty,
replace it.
5 Clean the pre-filter. If the filter is very dirty,
replace it.
6 Assemble the filter by performing the above
instructions in reverse order.
9 10 3

Replace the spark plug

For the frequency of this intervention
see chapter 13
Before removing the spark plug, clean around its
mounting.
For the type of spark plug and relative spark gap,
please refer to "0 TECHNICAL DATA TABLE".
9 10 4

Cleaning the air intake

For the frequency of this intervention
see chapter 13
See figure (18:B; 19:B; 19A:B).
The engine is air-cooled.
A blocked cooling system can damage the engine.
More meticulous cleaning of the cooling system
should be carried out during each basic service.
ENGLISH

9 11 LUBRICATION (20)

For the frequency of this intervention
see chapter 13
Object
Wheel
bearings
Steering
spring
Gear
cable

9 12 FUSES (20:D)

Fault
In the event of electrical faults, check/
replace the fuse.
If the problem persists, contact an
authorized servicing centre to get the
relative repairs carried out.

10 ASSISTANCE AND REPAIRS

This manual provides all the necessary infor-
mation to run the machine and for correct basic
maintenance operations which can be performed
by the user.
Any regulations and maintenance operations not
described herein must be carried out by your De-
aler or Authorized Service Centre, which have the
necessary knowledge and equipment to ensure
that the work is carried out correctly, maintaining
the correct degree of safety and the original opera-
ting conditions of the machine.
Before performing any servicing opera-
tions:
a Place the machine on a flat surface.
b Activate the parking brake (11:B)
c Stop the engine.
d Remove the key from the ignition.
Authorized service workshops carry out guaran-
teed repairs and maintenance.
Always use genuine spare parts.
Action
3 grease nipples
Use a grease gun filled
with universal grease.
Use multipurpose grease
Lubricate the cable ends
with oil when each control
is activated.
EN
Fig
(20:A)
(20:B)
(20:C)
Fuse
(20:D)
21