Connecting The Network Cable; Preparing A Wireless Antenna; Connecting The Power Cord; Turning On The Unit - Yamaha R-N803 Manual De Instrucciones

Connections

Connecting the network cable

Connect the unit to your router with a commercially-
available STP network cable (CAT-5 or higher straight
cable).
Note
Use an STP (Shielded Twisted Pair) cable to prevent
electromagnetic interference.
Internet
Modem
Router
Mobile device
(such as iPhone)
NETWORK
SPEAKERS
A
This unit (rear)

Preparing a wireless antenna

If you use a wireless network connection or a Bluetooth
connection, erect the wireless antenna. For information on
how to connect the unit to a wireless network, see
"Connecting to network" (p. 15). For information on using
this unit with a Bluetooth device, see "Playing back music
via Bluetooth" (p. 32).
Notice
Do not apply excessive force on the wireless antenna. Doing so
may damage the antenna.
14
En
Network Attached
Storage
(NAS)
WAN
LAN
PC
Network cable
AC IN
(R-N803)

Connecting the power cord

After all the connections are complete, connect the
supplied power cord to this unit and then to an AC wall
outlet.
WARNING
(General model only)
Before connecting the power cord, make sure you set
VOLTAGE SELECTOR of this unit according to your
local voltage. Improper setting of VOLTAGE SELECTOR
may cause fire and damage to this unit.
VOLTAGE SELECTOR
110 –120 V 220 –240 V

Turning on the unit

Press A (power) on the front panel to turn on the unit.
•
A (power)
AC IN
To the AC wall outlet
with the power cord