Tabla de contenido
Publicidad
ENglISh
Step 5: (fig. 5)
1. Place washers (B) onto two carriage bolts (A).
2. Insert he bolts through the front holes in the tractor
frame and the mounting holes in the bumper. The rear
mounting hole give the most clearance while the front
hole gives neater appearance. Use a hole that provides
enough clearance for the hood to stay in the raised
position when opened.
3. Install whizlock nuts (C) onto the bolts and tighten all
four bolts and nuts.
IMPORTANT: Before fully tightening nuts, be sure tractor
hood will stay in a raised position when opened.
CARRIAGE BOLT (A)
AND WASHER (B)
6
WHIZLOCK NUT
(C)
FIGURE 5
Step 6: (fig. 6)
1. Replace the browning shield using the front screws you
removed in Steop 2.
REPLACE
FRONT SCREWS
BROWNING SHIELD
REPLACE
FIGURE 6
Publicidad
Tabla de contenido
