To Remove/Replace Comfort Lining - Arai Helmet 2012 Manual De Instrucciones

RX-7GP / CORSAIR-V /QUANTUM / RX-Q
CHASER-V / VECTOR-2
22
English

TO REMOVE/REPLACE COMFORT LINING

The comfort lining is secured to the helmet by plastic bosses.
To remove the lining, undo bosses by grasping the lining as close to each
boss as possible and
pulling straight up. Note the fore & back, top & bottom sides of the lining
for replacement.
SIGNET-Q lining is equipped with removable temple pads to offer a bit
more room if desired. To remove pads, open the pocket on each side of
the lining and gently remove pad from the pocket. If you wish to replace
them in the pockets, use double sided tape to fix them in place.
To wash the comfort lining, put it into lukewarm water with small amount
of laundry soap or your own shampoo and wash gently by hand. Rinse
well with fresh water and wipe off with a soft cloth. Dry it in the shade at
ambient temperature.
WARNING:
Never use petrol, thinner, benzene or any other solvents.
To replace the lining, place the bosses over their plastic receptacles and
push them home.
WARNING:
When reinstalling the comfort lining, be sure the lining is properly
positioned along the inside shape of the EPS (a.k.a. Styrofoam) liner.
If the comfort lining is not properly installed, the frame of the comfort
lining may fold when you put on and take off the helmet, which may
injure your skin, etc. Whenever you feel something is wrong with the
comfort lining, check that the lining is properly installed.