To Remove/Replace Cheekpads - Arai Helmet 2012 Manual De Instrucciones

English

TO REMOVE/REPLACE CHEEKPADS

When first servicing the cheekpads, it is suggested that you do only one at
a time so that the other can be used as a reinstallation guide.
To remove the cheekpads, first undo chinstrap. Lift up the neckroll tab,
which is inserted under the black covering at the forward lower edge of
the pad assembly.
RX-7GP / CORSAIR-V / QUANTUM-ST / RX-Q / SIGNET-Q
Pull the pad toward the rear of the helmet, then inward to release and
slide it off the strap.
CHASER-V / VECTOR-2 / AXCES-Ⅱ / REBEL
Pull the pad toward the front of the helmet, then inward to release and
slide it off the strap.
To take off the fabric covering for washing, peel the covering off over the
rear edge of the cheekpad assembly until all the fabric is on the face side
surface. Then draw the covering through the opening by grasping the
rectangular collar and pulling.
RX-7GP / CORSAIR-V / QUANTUM / RX-Q / SIGNET-Q / CHASER-V /
VECTOR-2 cheekpad is equipped with a 5mm surface foam layer. The
layer is removable to offer a bit more room if desired.
16