To Remove/Replace Chinstrap Covers - Arai Helmet 2012 Manual De Instrucciones

Left chinstrap cover (D-ring side)
Couvercle gauche de la jugulaire (côté anneau en forme de D)
Linke Kinnriemenabdeckung (D-Ring-Seite)
24
Right chinstrap cover (long side)
Couvercle droit de la jugulaire (côté long)
Rechte Kinnriemenabdeckung (lange Seite)
English

TO REMOVE/REPLACE CHINSTRAP COVERS

RX-7GP / CORSAIR-V / QUANTUM-ST / RX-Q / SIGNET-Q
To remove the chinstrap covers, first remove the cheekpads as per
previous instructions.
Remove the plastic chinstrap anchor cover from the steel chinstrap anchor
and slide the cover off the chinstrap.
Note the right and left, inside and outside of the chinstrap covers for
replacement.
To wash the chinstrap covers, put them into lukewarm water with small
amount of laundry soap or your own shampoo and wash gently by hand.
Rinse well with fresh water and wipe off with a soft cloth. Dry them in the
shade at ambient temperature.
WARNING:
Never use petrol, thinner, benzene or any other solvents.
To replace the left chinstrap cover (D-ring side), ensure the female
chinstrap end snap side of the chinstrap and the leatherette side of the
chinstrap cover both face outward, slip the chinstrap cover onto the
chinstrap.
Position the plastic chinstrap anchor cover over the steel anchor and push
the cover in the anchor until the tab on the back of the cover snaps fully
home.