EAS ELECTRIC EMH750CGB Manual De Instrucciones página 39

Cleaning and Maintenance
BURNERS
Remove the burner lids and flame spreaders by pulling them upwards

and away from the top plate.
soak them in hot water and a little detergent or washing up liquid.

After cleaning and washing them, wipe and dry them carefully. Make

sure that the flame holes are clean and completely dry.
Wipe the fixed parts of the burner cup with a damp cloth and dry

afterwards.
Gently wipe the ignition device and flame supervision device with a

well wrung-out cloth and wipe dry with a clean cloth.
B efore placing the burners back on the top plate, make sure that the

injector is not blocked.
Re-assemble the auxiliary, semi-rapid, rapid and triple-
crown burners as follows:
1. Place the flame spreader (4) on to the burner cup (5) so that the ignition
device and the flame supervision device extend through their respective
holes in the
place correctly.
2. Position the burner lid (1, 2, 3) onto the flame spreader (4) so that the
retaining pins fit into their respective recesses.
Replace parts in the correct order after cleaning.
- Do not mix up the top and bottom.
- The locating pins must fit exactly into the notches.
2 1
3
4
5
6
7
flame spreader. The flame spreader must click into
2
3
4
7
6
5
14 V.4