TROUBLESHOOTING
iPod™
Note
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to your iPod (see
page 12).
Status message
iPod Connecting
Connect error
Unknown iPod
iPod
iPod Unplugged
USB
Note
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to the USB device
(see page 12).
Status message
Not Connected
Not Supported
Over Current
26
En
Cause
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
Your iPod is properly stationed in an
iPod terminal.
Your iPod was removed from an iPod
terminal.
Cause
The USB device is not connected
firmly.
Connected the USB device not playable
on this unit.
Connected the USB device not playable
on this unit.
Connected the USB device diagonally.
Remedy
Turn off this unit and reconnect the iPod.
Try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, iPod mini,
and iPod Touch are supported.
Station your iPod back in an iPod terminal.
Remedy
Connect the USB device again.
Connect playable USB device.
Disconnect the USB device. Change input source
other than USB and select USB as input source
again. Then connect playable USB device again.
See
page
12
—
—
12
See
page
12
12
12