Battery Charge - Blatchford Elan Serie Guía De Usuario

Battery Charge/Status Indication
To check the battery charge status, tilt the
foot down vertically and hold stationary for
4 seconds. The LED at the rear of the Elan will
flash blue, 1-3 times (see table) to indicate the
charge status and then repeat. Tilt the foot
again to check the battery status again.
Note... This feature may be enabled/disabled
by the Practitioner, refer to the Clinician's Manual
for details.
LED
3 flashes
2 flashes
1 flash
Elan Status Indication
1. Single Flash
When the charger is disconnected the LED will flash once to indicate correct start up.
2. Continuous Flash
If the LED flashes continuously after disconnection this may indicate an error has been
detected. To reset the Elan, reconnect and then disconnect the charger the Elan should flash
once to indicate correct start up. If the Elan will not reset contact your service provider.
3. Alternate Long-Short Flash
Indicates Battery shutdown; If this is seen shortly after an adequate charging period,
contact your service provider a battery service may be required.

Battery Charge

Maximum
High
Low
8
Blue
After charging the Elan
the LED may indicate 2 or
3 flashes this will depend
on the charging time, the
age and condition of the
battery.
938318SPK1/1-0321