Ups Top And Side Panels - Powerware 3110 Guia Del Usuario

3. Start the UPS by pressing the switch as shown in Figure 2
NOTE Let the unit charge the battery for at least 3 hours. You may use the unit while
the battery charges, but the battery backup runtime will be reduced until the battery is
fully charged. This will take up to 8 hours after a full discharge while the UPS is fully
loaded.

UPS Top and Side Panels

Figure 1 and Figure 2 identify features of the 120V (USA) models, with
attached input line cord. Figure 3 and Figure 4 identify features of the
230V (European) models, which have a connector for the input line
cord as well as IEC output receptacles.
:
Powerware 3110 User's Guide Rev A www.powerware.com
®
or Figure 4 on page 4. The
that power is available from the UPS output receptacles.
The unit beeps and the front panel LEDs illuminate several

times. The indicator remains on, indicating normal
operation.
If the unit continues to beep, or if the
though input power is available from the wall outlet, see
"Troubleshooting" on page 13.
Fault Indicator
Output Receptacles
(Battery and Surge Protection)
Figure 1. 120V Model Top Panel

indicator illuminates indicating

indicator is off even
Power Indicator
Output Receptacles
(Surge Protection Only)
Installation
3