Select The User; Select The Measuring Mode: Standard Or Measurement Averaging Mode; Measurement Averaging Mode Technology (Mam) - Microlife BP3GT1-6X Manual De Instrucciones

4.7. Select the user

This blood pressure monitor is designed to store 120 measurements for each of two
users. In addition, there is a guest mode in which results are not stored.
Before taking a measurement, be certain that the
correct user has been selected.
a) With the power switch on and the unit in standby, press
and hold the user to cycle through users ("1,""2" or guest
mode).
b) To confirm your selection wait 2-3 seconds.
4.8. Select the measuring mode:
standard or measurement averaging mode (MAM)
This instrument enables you to select either standard (single
measurement) or measurement averaging mode (automatic
triple measurement).
a) To select standard mode, push the switch on the left side of
the instrument down to Position "1."
b) To select Averaging mode push the switch upward to
Position "3." Note the "MAM" icon will illuminate on the
display.
If you select 1, then only one measurement will be taken. If
you select 3, the unit will inflate and deflate three times
resulting in one final average.

4.9. Measurement averaging mode technology (MAM)

• In Measurement Averaging Mode (MAM), three measurements are automatically
taken in succession and the result is then automatically analyzed and displayed.
Because your blood pressure constantly fluctuates, a result determined in this way is
more reliable than one produced by a single measurement.
• After adjusting the switch as described in section 4.8, the selected Measurement
Averaging Mode appears in the display as the MAM symbol.
• The bottom, right hand section of the display shows a 1, 2 or 3 to indicate which of
the 3 measurements is currently being taken.
• There is a resting period of 15 seconds between measurements. An hourglass will
appear during this period.
10
Guest Mode
1 3