Install The Finished Wall; Troubleshooting Procedures - Kohler K-1914 Guia De Instalacion

Cut template.
Mark bath profile line on drywall.

20. Install the Finished Wall

All Installations
If you have not already done so, carefully remove any protective tape from the bath rim.
NOTE: Use the provided template (if needed) to cut the bottom of the wall material to match the contour
on the rear of the bath.
Cover the framing with water-resistant wall material. Seal the joints between the bath rim edge and
the water-resistant wall material with silicone sealant.
Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall
material so it is 1/16" (2 mm) above the bath surface. Seal the joints between the bath rim and the
finished wall material with silicone sealant.
Install the faucet trim according to the instructions packed with the trim.

Troubleshooting Procedures

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualified
electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale
distributor.
Normal Operation Includes:
While filling the bath with water, some water is routed to the drip tray and drain through
the accumulator drain hose. It is normal to see or hear a trickle of water either during or
immediately after filling. The accumulator is draining into the drip tray.
1128535-2-B
Caulk the seam of wall and bath.
36 Kohler Co.