Disc Playback; Remote Control - Yamaha MCR-550 Manual De Instrucciones

Disc playback

Problem
No sound or The sampling rate of an MP3 or WMA
distorted sound file may not be compatible with this unit.
Disc playback does You may be using a CD-R/RW that is not
not start.
finalized.
The disc label may be upside down.
The disc may be defective.
MP3/WMA disc may not contain
sufficient music files to be played back.
The sampling rate of an MP3 or WMA
file may not be compatible with this unit.
Some button The disc loaded into the unit may not be
operations do not compatible.
work.
Playback does not The disc may be dirty.
start immediately
The disc loaded into the unit may not be
after pressing
compatible.
on the unit or on
the remote control.
If the unit was moved from a cold to
warm place, condensation may have
formed on the disc reading lens.
"No Disc" appears in
The disc loaded into the unit may not be
the display even compatible.
though a disc is in
The disc may be dirty.
the disc tray.
Disc is loaded upside-down.

Remote control

Problem
The remote control The remote control may be operated
does not work nor outside its operation range.
function properly.
The remote control sensor on this unit
may be exposed to direct sunlight or
lighting.
The battery may be worn out.
There are obstacles between the sensor of
this unit and the remote control.
Cause
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with this unit.
Finalize the CD-R/RW.
Check that the disc label is facing up.
Try playing back another disc. If this cures the
problem, the disc you want to play back is defective.
Check that your MP3/WMA disc contains at least
5 MP3/WMA music files. If the number of files is
small, the disc may not be recognized.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with this unit.
Remove the disc and then check whether the unit
supports the disc or not.
Wipe the disc clean.
Use a disc supported by the unit.
Wait for an hour or two until the unit adjusts to the
room temperature, and try again.
Use a disc supported by the unit.
Remove the disc and then wipe the disc clean.
Remove the disc and then load the disc with the
labeled side facing up.
Cause
For information on the remote control operation
range, refer to "Using the remote control".
Change the lighting or orientation of this unit.
Replace the battery with new one.
Remove the obstacles.
TROUBLESHOOTING
Remedy
Remedy
page
3
—
—
—
—
3
3
—
3
—
3
—
—
page
5
—
5
—
21
En