Electric Installation - Cata VALTO Instrucciones Para La Instalación, El Uso, El Mantenimiento

EN
the equipment.
- Shall not be held responsible for any damage caused by the incorrect insta-
llation, use or maintenance of the appliance.
- Reserves the right to make any changes to the equipment or this manual
without giving prior notice.
Should you need technical assistance or additional information about our pro-
ducts, please contact your distributor or an official, authorised technical service.

ELECTRIC INSTALLATION

Make sure the maximum air extraction flow rate for the appliances in the room does not exceed
4 Pa (0.04 mbar).The room must have adequate ventilation if an extractor hood is used simul-
taneously with appliances that run on gas or other fuels. The evacuated air must be extracted
through ducts that are used for evacuating fumes from appliances that run on gas or other
fuels. Regulations regarding air extraction must be complied with.
This product in intended for HOUSEHOLD USE only.
Use a rigid PVC pipe with a min. Ø l50 mm to evacuate fumes outside.
The above restrictions do not apply to hoods with no fumes outlet to outside (recirculation
system with activated charcoal filter).
Warning: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
Installation and connection
- This appliance is only intended for domestic use.
- Please observe the special installation instructions.
- The appliance is fitted with a plug and must only be connected to a properly installed earthed
socket.
- The mains voltage must correspond to the voltage specified on the rating plate.
- The socket must be installed and connecting cable must only be replaced by a qualified
electrician.If the plug is no longer to accessible following installation,an all-pole disconnecting
device must be present on the installation side with a contact gap of at lease 3mm.
-Adapters,multi-way strips and extension leads must not be used. Overloading can result in a
risk of fire.