Installing The Led Housing; Installing Color Filters - Optika Italy IM Serie Manual De Instrucciones

7.6

Installing the LED housing

• All models except IM-3LD4D
1. Insert the connector plug into the connector jack.
2. Push the LED housing gently into the holes of the illu-
mination unit. (Fig. 9)
• IM-3LD4D
The LED of the IM-3LD4D is already pre-installed on the
illuminator. No operation is therefore necessary. (Fig. 10)
7.7 Installing color filters
• Remove the filter holder, then install the color filter
you need. (Fig. 11 - 12)
1. Mount the color filter flat as shown in ①, checking that
they are not tilted.
• If the color filter is tilted or otherwise out of place
②, it may fall.
②
• Color filters can be stacked in the holder. This allows to
install as many filters as needed, as long as the whole
thickness is less than 11 mm.
①
Page 19
F ig. 9 F ig. 9
F ig. 10 F ig. 10
F ig. 11 F ig. 11
F ig. 12 F ig. 12