Kit Assembly - Metra 99-2011 Instrucciones De Instalación

KIT PREPARATION
Cadillac Fleetwood, Fleetwood Brougham 1990-1995
1. Using carriage bolts and
Keps nuts supplied, mount
the factory brackets to the
radio-trim-plate/radio-
bracket assembly (keeping
in mind which bracket is top
and which one is bottom).
Continue to
Kit Assembly
"All Applications"
*Note: Figure A shows
the radio installed for
illustrative purposes only.
(CONT)
Top factory bracket
TOP FACTORY BRACKET
Bottom factory bracket BOTTOM FACTORY BRACKET

KIT ASSEMBLY

For ISO DIN radio provision with pocket
1. Insert the radio brackets to the edge of
the radio trim plate. (Figure A)
2. Secure the pocket to the radio brackets
with (4) #8 X 3/8" Phillips screws supplied.
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Insert the radio through the rear of the
completed pocket assembly, and then
secure using screws supplied with the
radio. (Figure B1)
Continue to "All Applications"
on the next page
(Figure A, for both provisions)
For ISO DDIN radio provision
1. Insert the radio brackets to the edge of
the radio trim plate. (Figure A)
2. Insert the radio into the completed assembly
through the rear, and secure using screws
supplied with the radio. (Figure B2)
Continue to "All Applications"
on the next page
(Figure B1)
(Figure B2)
REV. 1/6/2020 INST-99-2011
23