Measurement Procedure - Walgreens WGNBPA-750 Manual De Instrucciones

MEASUREMENT PROCEDURE

Important Notes:
• Blood pressure changes with every heartbeat and is in
constant fluctuation throughout the day.
• Blood pressure measurement can be affected by the
position of the user, his or her physiologic condition
and other factors. For greatest accuracy, wait 1 hour
after exercising, bathing, eating, drinking beverages
with alcohol or caffeine, or smoking to measure blood
pressure.
• Before measurement, it is suggested that you sit
quietly for 15 minutes as measurements taken during
a relaxed state will have greater accuracy. You should
not be physically tired or exhausted while taking a
measurement.
• During the measurement, do not talk or move your
arm or hand muscles.
• See page 31 for additional notes regarding your blood
pressure measurement.
If you are using this blood pressure monitor for the first
time, please remove the protective film from the screen.
19
Using Single Measurement Mode:
1. Please make sure the Triple Check measurement switch,
located on the back of the unit, is in the OFF position.
2. Press the USER-SELECT button to choose User 1 or User 2.
Pulse
/min.
START
USER
MEM
1/2 STOP
After the user number is selected, press the START/STOP
button to confirm the chosen user.
SYS.
3. With the cuff wrapped around your arm, press the START/
mmHg
STOP button. Do not inflate the cuff unless it is wrapped
around your arm. All digits will light up to check the display
functions. The checking procedure will be completed after
DIA.
about 3 seconds.
mmHg
Pulse
/min.
START
USER
MEM
1/2 STOP
Note:
If the Rest Assure feature is ON, the 5 minute countdown will
begin after the checking procedure is complete.
SYS.
mmHg
DIA.
mmHg
20