Calibration; Troubleshooting - Medline MDSTH1002 Manual Del Usuario

CALIBRATION

The thermometer is initially calibrated at the time of manufacture. If the thermometer is
used according to the instructions, periodic recalibration is not required. If at any time you
question the accuracy of the measurement, please contact the retailer immediately. Don't
attempt to modify or reassemble the thermometer.

TROUBLESHOOTING

Problem
No response /
Automatic reset
when pulling out
the insulator
18 MDSTH1002 (PIC-00364) | Revision: 09/17/20
Checklists
Battery dead?
Incorrect polarity?
Poor battery contact?
The measured temperature is lower
than 89.6°F /32.0°C or higher than
109.3°F /42.9°C
Please check the operation method
Hardware problem
Please check if the
infrared sensor is clean
Countermeasures
Change batteries
Take out battery,
reinsert battery
correctly
Follow steps in User
Manual for proper
measurement and probe
sensor placement.
Contact the
manufacturer or
distributor
Clean the infrared
sensor with cotton
swab according to
user manual