3. Use metal shears to cut along the exterior braided armor, taking care not to cut into the cable
4. Trim the exterior braided armor back to the cut mark, and remove stray wires from the cut.
5. Mark the cable jacket 1.25"/3 cm from the cut end of the exterior braided armor.
6. Using a razor knife, cut carefully around the cable jacket, without cutting into the inner braided
2-20
METTLER TOLEDO IND246 and IND246 POWERCELL Installation Manual
jacket or the outer drain wire.
Figure 2-30: Exterior Braided Armor Cut, Outer Drain Wire Exposed
Figure 2-31: Exterior Braided Armor Trimmed Back
shield.
Cut armor
Outer drain wire
Figure 2-32: Marking the Cable Jacket
Cable jacket
64084463
|
03
|
12/2017