Starting Operation - Bosch POF 1200 AE Manual Original

24 | English
– Use dust extraction whenever possible.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Mounting the Extraction Adapter
The extraction adapter 28 can be mounted with
the hose connection to the front or to the rear.
When mounting with the hose connection in
front, the chip shield 5 must be removed first.
Fasten the extraction adapter 28 with the two
knurled screws 29 to the base plate 6.
To ensure optimum extraction, the extraction
adapter 28 must be cleaned regularly.
Connecting the Dust Extraction
Insert an extraction hose (Ø 35 mm) 27 (acces-
sory) into the mounted extraction adapter. Con-
nect the extraction hose 27 to a vacuum cleaner
(accessory).
The machine can be plugged directly into the re-
ceptacle of a Bosch all-purpose vacuum cleaner
with remote starting control. The vacuum clean-
er starts automatically when the machine is
switched on.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Mounting the Chip Shield (see figure C)
Insert the chip shield 5 from the front into the
guide in such a manner that it engages. To re-
move the chip shield, grasp it by the sides and
pull it off toward the front.
1 609 929 S76 | (21.7.09)
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Preselecting the Speed
The required speed can be preselected with the
thumbwheel 23 (also while running).
1 – 2 low speed
3 – 4 medium speed
5 – 6 high speed
The values shown in the chart are standard val-
ues. The necessary speed depends on the mate-
rial and the operating conditions, and can be de-
termined by practical testing.
Material
Hardwood
(Beech)
Softwood (Pine)
Particle Board
Plastics
Aluminium
Switching On and Off
Adjust the depth-of-cut before switching on or
off; see Section "Adjusting the Depth-of-cut".
To start the machine, first push the lock-off but-
ton for the On/Off switch 1 and then press the
On/Off switch 22 and keep it pressed.
POF 1400 ACE: A lamp illuminates the routing
area.
To switch off the machine, release the On/Off
switch 22.
Router bit Thumb-
diameter (mm) wheel 23
4 – 10
12 – 20
22 – 40
4 – 10
12 – 20
22 – 40
4 – 10
12 – 20
22 – 40
4 – 15
16 – 40
4 – 15
16 – 40
Bosch Power Tools
5 – 6
3 – 4
1 – 2
5 – 6
3 – 6
1 – 3
3 – 6
2 – 4
1 – 3
2 – 3
1 – 2
1 – 2
1