Howto Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation AIRE DELUXE FP6284 Serie Manual De Instrucciones

NOTE: This step is applicable after the neccessary
wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care
not to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)

How to Assemble Your Ceiling Fan Blades

Remove and discard the five rubber motor stops
1.
from the motor assembly by removing the screws.
(Figure 1)
Position the blade over the blade holder with
2.
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a phillips screwdriver, tighten 3/16˝-24 washer
head screws and fiber washers to secure the blade
to the blade holder. (Figure 2)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.

Howto Install Your Canopy Housing

Blade Holder
HARDWARE USED:
3/16˝-24
WASHER HEAD
SCREWS
FIBER WASHER
11
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Figure 1
3/16˝-24 Washer Head
Screws and Fiber Washer
(3 each per blade)
Figure 2
x 15
x 15
Blade