BONFIGLIOLI ACTIVE CUBE Guia De Inicio Rapido página 104

Key
A0100
A0400
A4000
A8000
GB
Key
F00 00
F05 00
07
F07 00
01
F11 00
F12 05
7.2 Status messages during commissioning (SS...)
The following status messages are possible during Setup:
Status message
SS000 OK
SS001 PC Phase 1
SS002 PC Phase 2
SS003 STO
102
Warning messages
Mains phase failure, check mains fuses and supply cable.
Limit frequency reached; output frequency is limited.
DC link voltage has reached the type-specific minimum.
Application-specific warning: For detailed functions, refer to Operating
Instructions.
Current Error
troubleshooting easier, an error code is displayed.
The error message can be acknowledged via the control
unit buttons and STO input.
Meaning
No fault has occurred.
Overloaded, check load situation and ramps.
Message from phase monitoring, check motor and wiring.
DC-Link Voltage
DC link voltage too high, check deceleration ramps and connected
brake resistor.
DC link voltage too low, check mains voltage.
Output frequency
Output frequency too high, check control signals and settings.
Safety function STO
Fault message of 5-second monitoring. Shut-down paths STOA and
STOB were not actuated at the same time, but with an offset of more
than 5 seconds. Check addressing of shut-down paths or control of
protection provision.
Auto set-up routine has been carried out.
The plausibility check (PC) of the motor data is active.
The calculation of dependent parameters is active.
The parameter identification requires release on
digital input STOA and STOB.
Quick Start Guide ACU
Meaning
259 and
Error messages
Overload
Output current
Meaning
310
Last Error
make
10/18