AMiO DBC-4A Manual De Instrucciones página 5

Digital battery charger DBC-4A - User manual
Charging modes:
Battery voltage 6V capacity below 14Ah ambient temperature above 0ºC – FULL 7,2V
Battery voltage 6V capacity below 14Ah ambient temperature below 0ºC – FULL 7,4V
Battery voltage 12V capacity below 14Ah ambient temperature above 0ºC – FULL 14,3V
Battery voltage 12V capacity below 14Ah ambient temperature below 0ºC – FULL 14,7V
Battery voltage 12V capacity above 14Ah ambient temperature 0ºC – FULL 14,3V
Battery voltage 12V capacity above 14Ah ambient temperature 0ºC – FULL 14,7V,7V
Examples of display indications:
Incorrect connection to the battery, check the pole connection. Red „+" black „-". The
error will also appear if the battery is deeply discharged or damaged.
Correct connection, the display shows the battery voltage
Battery fully charged
» Before the use of the charger is started, it is absolutely essential to check its technical condition. Check
the condition of the connecting cables and the plug - if their damage is observed, replace the damaged
element. Check the condition of the housing - if it is damaged, the housing must be subjected to
detailed inspection carried out by an authorized professional.
» Check that the mains voltage corresponds to the rated voltage on the type plate. If you are using an
extension cord, the cross-sectional area of the wires must have the correct rating for the power supply
to the appliance.
» Before starting the battery charging, it is absolutely essential to disconnect the battery from the installa-
tion in which the battery is used. Use the guidelines for the battery charging, included in the manual for
the car or other equipment.
» Slacken or remove the plugs from the respective battery sections (if they are present), check the acid
level in the battery and if necessary, fill it up with decriminalized water.
» Connect the charger red clamp to the end of positive pole of the battery „+", and the black clamp to the
negative pole „-". Place the charger at the maximum distance from the battery, then connect the
charger to the power source, using the power cord.
» Charging begins after connecting the power cable to a power source. The display shows the current
battery voltage. When the charger indicates that the battery is fully charged (FULL on the display),
disconnect the charger from the power supply, remove the cables connected to the battery and tighten
the caps to check the electrolyte status on the battery (if exist).
» Disconnect the battery charger from the power source, remove the cables connected to the battery and
tighten the plugs for the electrolyte level control on the battery.
» The battery is ready for use.
» Avoid incomplete charging of the battery as this shortens its life.
Do not dispose of the electronic equipment together with standard household waste.
In pursuance of the European Directive 2002/96/EC on waste electrical and electronic equipment (WEEE)
and its incorporation into the national law, the waste electrical and electronic equipment must be subject
to separate collection and recycling. The waste equipment can be returned to an electronic waste
collection point, which is involved in the disposal of the equipment in pursuance of the national recycling
and waste act.
USE
RECYCLING
4 / 10