Battery Installation/Replacement; Setting The Date/Time - HealthSmart 04-825-001 Manual De Instrucciones

Battery Installation/Replacement

Replace the batteries when the Low Battery
symbol appears on the display, Fig. 1, or when the
display remains blank when
Button is pressed.
To change the batteries:
1. Open the battery cover, Fig. 2.
2. Making sure the battery polarity is correct,
install two AAA alkaline batteries, Fig. 3.
3. Close the battery cover, Fig. 4.
NOTE: It is recommended to remove the batteries if the unit will not be used for
an extended period of time. Rechargeable batteries are not suitable for this
monitor.
Fig. 2
Fig. 3
the POWER
Fig. 1
Fig. 4
10

Setting the Date/Time

NOTE: When the unit is off, the date and time will still appear at the top of
the screen.
1. When the unit is off, press both the POWER and MEMORY button at the
same time for two seconds. The month will begin to flash, Fig. 1.
2. Press the MEMORY button to change until the desired number appears.
NOTE: To scroll through the numbers quicker, hold down the
MEMORY button.
3. Press the POWER button to set the entry.
4. The date, Fig. 2, followed by the hour and minutes will blink. Repeat
steps 2 and 3 to adjust the date/time setting.
5. After setting the minutes, the unit will automatically exit out of
the date/time setting mode, Fig. 3.
NOTE: The time is expressed in 24hr military time. The chart below explains
the time conversion.
Regular Time Military Time
(12 hours) (24 hours)
12 am
0
Midnight
1 am 1
2 am 2
3 am 3
4 am 4
5 am 5
6 am 6
7 am 7
8 am 8
9 am 9
10 am 10
11 am 11
Regular Time Military Time
(12 hours) (24 hours)
12 pm
12
Noon
1 pm 13
2 pm 14
3 pm 15
4 pm 16
5 pm 17
6 pm 18
7 pm 19
8 pm 20
9 pm 21
10 pm 22
11 pm 23
11
Fig. 1
Fig. 2
Fig. 3