How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation SCHOLAR LP8343LABA Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

NOTE: This step is applicable after the neccessary wiring is completed.

1. Remove one of the two shoulder screws in the

hanger bracket. Loosen the second shoulder screw

without fully removing it. Assemble canopy by

rotating key slot in canopy over shoulder screw in

hanger bracket. Tighten shoulder screw. Fully

assemble and tighten second shoulder screw that

was previously removed. (Figure 1)

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy

housing and not pinched between the housing and the

ceiling.

Securely attach and tighten the canopy screw cover

over the shoulder screws in the hanger bracket utilizing

the keyslot twist-lock feature. (Figure 2)

Position the blade over the blade holder with

threaded posts showing. Make sure the bottom edge

of the blade is fully seated against the blade holder.

head screws and fiber washers to secure the blade

to the blade holder. (Figure 1)

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled

may result in damage to the fan blades.

2. Secure the blade holders to the bottom of the motor

assembly using the 1/4 -20 screws. (Figure 2)

NOTE:

Periodically check blade holder hardware and

resecure if necessary.

To reduce the risk of personal injury, do not bend the

blade holders when installing, balancing the blades

or cleaning the fan. Do not insert foreign objects in

between the rotating blades.

To reduce the risk of electric shock, disconnect the

electrical supply circult to the fan before installing

light kit.