Maintenance; How To Clean Your Ceiling Fan Blades; Troubleshooting - Fanimation AIREHUG LP7668LBL Manual De Instrucciones

Periodic cleaning of your new ceiling fan is the only
maintenance necessary.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the finish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to finish.

How to Clean Your Ceiling Fan Blades

Periodic light dusting of the blades is recommended.
A feather duster will work best.
For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.
Trouble
1. FAN WILL NOT START
2. FAN SOUNDS NOISY
3. FAN WOBBLES
EXCESSIVELY

Maintenance

Troubleshooting

Probable Cause
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan, or loose
switch wire connections in the switch housing.
3. Dead battery in remote control.
4. Reverse switch in neutral position.
1. Blades not attached to fan.
2. Loose screws in motor housing.
3. Wire connectors inside housing rattling.
4. Motor noise caused by solid state variable speed
control.
1. Screws securing fan blade to motor hub are loose.
2. Ceiling bracket and/or ceiling outlet box is not
securely fastened.
Do not use solvents when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of electrical shock.
Avoid using water, cleansers, or harsh rags, which
can warp and ruin the blades.
WARNING
1. Check main and branch circuit fuses or circuit
2. Check line wire connections to fan and switch wire
CAUTION: Make sure main power is turned off !
3. Replace with new battery.
4. Make sure reverse switch position is all the way to
1. Attach blades to fan before operating.
2. Check to make sure all screws in motor housing are
3. Check to make sure wire connectors in switch
CAUTION: Make sure main power is turned off !
4. Some fan motors are sensitive to signals from
1. Check to be sure screws which attach the fan blade
2. Tighten the ceiling bracket screws to the outlet box,
13
CAUTION
Suggested Remedy
breakers.
connections in the switch housings.
one side.
snug (not over-tight).
housing are not rattling against each other or against
the interior wall of the switch housing.
solid-state variable speed controls. Solid-state
controls are not recommended, choose an alternative
control method.
to the flywheel are tight.
and secure outlet box.