Filling The Oil Reservoir - Craftsman CMECSP610 Manual De Instructiones

English
Fig. E
Fig. F
Replacing the Saw Chain (Fig. A, G)

CAUTION: Sharp chain. Always wear protective
gloves when handling the chain. The chain is sharp
and can cut you when it is not running.

WARNING: Sharp moving chain. To prevent
accidental operation, ensure the tool is unplugged
before performing the following operations. Failure to
do this could result in serious personal injury.
1. Rotate the chain tensioning screw
to lessen chain tension.
2. Remove sprocket cover
the Guide Bar and Saw Chain section.
3. Lift the worn saw chain
guide bar 4 .
4. Place the new chain in the slot of the guide bar, making
sure the saw teeth are facing the correct direction by
matching the arrow on the chain with the graphic on
the sprocket cover 6
5. Follow instructions for Installing the Guide Bar and
Saw Chain.
10
5
1/8" (3 mm)
8 counterclockwise
6 as described in Installing
5 out of the groove in the
shown in Fig. G.
4
Fig. G
Saw Chain and Guide Bar Oiling (Fig. A)
Auto Oiling System
This chainsaw is equipped with an auto oiling system that
keeps the saw chain and guide bar constantly lubricated.
The oil level indicator
chainsaw. If the oil level is less than a quarter full, unplug the
chainsaw and refill with the proper oil.
nOTE: Use a high quality bar and chain oil for proper saw
chain and bar lubrication. As a temporary substitute, a non-
detergent SAE30 weight motor oil can be used. The use of
a vegetable based bar and chain oil is recommended when
pruning trees. Mineral oil is not recommended because it
may harm trees. Never use waste oil or very thick oil. These
may damage your chainsaw.

Filling the Oil Reservoir

1. Remove the oil cap
recommended chain oil until the oil level has reached
the top of the oil level indicator
2. Refit the oil cap.
3. Periodically switch the chainsaw off and check the oil
level indicator to ensure the bar and chain are being
properly oiled.
Attaching Extension Cord to Chainsaw
(Fig. H)
An extension cord retainer
switch handle. It prevents the extension cord from
coming unplugged.
1. Double the extension cord and insert it into the slot
in the end of the handle area as shown in Fig. H.
2. Hook the loop formed by doubling the cord over the
cord retainer
it is firmly retained in the handle.
3. Plug the receptacle end of the chainsaw power cord
into the extension cord adapter
4. Plug the receptacle end of the extension cord into the
extension cord adapter
NOTE: Always keep the extension cord away from the
cutting area and position the extension cord so that
it will not be caught on branches, and other material,
during cutting.
17 shows the level of the oil in the
16 and fill the reservoir with the
17 .
13 is built into the
13 . Gently tug on the cord to ensure that
15 .
15 .
14
12