Fig. Y
28
Fig. Z
28
Fig. AA
12
Adjusting the Pole Length (Fig. BB, CC)
WARNING: Always check to make sure that
the extension pole adjust lever is completely
locked and that the extension pole does not
move before using or transporting the tool. Not
locking the pole extension adjust lever could
result in the tool head unexpectedly moving,
creating a hazardous condition. Periodically
check the extension adjust lever to ensure that it
is completely locked.
1. Unlock the extension pole adjust lever
Fig. BB.
2. With one hand firmly grasping the extension
assembly
, slide the extension pole
26
the other hand as shown in Fig. CC. This will reveal the
extension pole
32
.
nOTE: The tool can be operated at any length of
the extension pole
3. Once the desired extension length is acquired, lock the
pole extension adjust lever
pole in place. Ensure the extension pole does not move
before use.
37
10
29
30
29
33
31
as shown in
out with
32
31
to secure the extension
Fig. BB
32
Fig. CC
32
DISASSEMBLY
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Detaching Chainsaw and Extension Pole
Assembly (Fig. X–AA)
WARNING: Sharp moving blade. To prevent
accidental operation, insure that unit is off and
disconnected from a power source before performing
the following operations. Failure to do this could result
in serious personal injury.
1. Rest the pole saw assembly flat on the ground.
2. Unplug the receptacle end of the pole saw adapter
power cord
33
from the chainsaw power cord
shown in Fig. AA.
3. Remove the pole saw adapter plate
pole saw adapter
28
counterclockwise. Refer to Fig. Z
4. Remove the chainsaw
adapter plate
29
to the pole saw adapter
use. Refer to Fig. X.
Disassemble the Pole Extension from the
Handle Assembly (Fig. U)
1. Loosen the threaded sleeve and then pull the two
halves apart.
POLE SAW OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
31
26
29
from the
by twisting the locking knob
37
. Reassemble the pole saw
28
English
26
12
as
for later
15