Etherma solamagic S2 Instrucciones De Montaje Y Uso página 105

Programming the wireless remote control
Important: • Only those heaters should be connected to the mains that are
to undergo programming to a hand-held transmitter key. This
allows the programming of several receivers (multi-power).
Previously programmed devices can remain connected to the
mains.
• Use of other components with a wireless-signal interface
(e.g. wireless PC mouse and keyboard) may result in faulty
operation of the wireless receiver. Switch off all other wireless
components, particularly when programming.
• For device type D2, the LED operating display supports pro-
gram progress:
LED A: Programming mode
LED B: Time switching
LED C: Wireless transmission blocked
• The wireless receiver is briefly disabled after command entry
using the hand-held transmitter.
Initial
programming: The heater to be programmed is connected to the mains (LED
C flashes quickly). Brief pressing of the desired key 1 to 4 on
the hand-held transmitter triggers wireless receiver program-
ming, heating tube starts at low level (LED A flashes quickly).
Repeated pressing of the same key confirms the programming,
heating tube switches to top level (LED A flashes quickly).
If desired, time-out switching can be programmed by double-
clicking: If the programmed key is pressed briefly twice in suc-
cession, the heater will switch off in 30 minutes, the heating tube
activates for 2 seconds (LED B flashes quickly). Double-clicking
again increases the heating duration to 60 minutes, heating tube
illuminates for 4 seconds (LED B flashes at medium speed).
Double-clicking again increases the shut-down to 90 minutes,
heating tube illuminates for 6 seconds (LED B flashes slowly).
Double-clicking once more switches the time control off. The
programming cycle for time-out switching begins again from the
beginning.
Programming is ended by long pressing of the programmed key
of the hand-held transmitter. The heating tube confirms that pro-
gramming is completed by operating for two seconds (all three
LED's light up briefly).
105
05/2018