After Each Use - Remington HC5302 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 30
ENGLISH
, STEP 1 – Nape of the neck
Set the comb to 3mm or 6mm.
Hold the clipper with the blade teeth pointing upwards. Begin starting at
the centre of the head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair,
trimming just a little at a time.
, STEP 2 – Back of the head
With the comb set at 12mm or 18mm, cut the hair at the back of the head.
, STEP 3 – Side of the head
With the comb set at 3mm or 6mm, trim sideburns. Then change to the
longer 9mm guide comb and continue to cut the top of the head.
, STEP 4 – Top of the head
Use the longer length comb attachment and set it to 24mm or 27mm then
cut hair on top of the head against the direction in which the hair normally
grows.
For longer hair on top, use the longer length comb attachment (24 – 44mm)
to achieve the desired style.
Always work from the back of the head.
, STEP 5 – The finishing touches
Use the clipper without an attachment comb for close trimming around the
base and sides of the neck.
To produce a clean straight line at the sideburns, reverse the hair clipper.
Place the reversed clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
C CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality blades.
To ensure long lasting performance of your clipper, clean the blades and unit
regularly.
Always keep the attachment guide comb on the trimmer blade.

, AFTER EACH USE

Ensure the appliance is switched off and unplugged from the mains before
cleaning.
Brush the accumulated hair from the blades. Do not submerge the clipper in
water.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido