Kohler K-13108 Guia De Instalacion página 4

Wall Plate Hole Locations
Wall Plate
Holes
2. Prepare the Site — Wall Plate(s)
For Multiple-Post Accessories
NOTE: Take into account the length of the accessory components to
determine the required distance between the post center points.
Consult the roughing-in diagrams to determine the dimensions.
Mark the vertical and horizontal center lines for each post. Use a
level to ensure that all center points are level.
For Single-Post Accessories
Mark the vertical and horizontal center lines for the post. Consult
the roughing-in diagrams to determine the dimensions.
3. Mark and Drill the Pilot Holes
Vertically align the holes on each wall bracket. Make sure the
larger hole is oriented as shown in the illustration.
If the installation requires multiple posts, confirm that the center
points are even using a level.
NOTE: There is no provision for later adjustment if the center points
and resulting pilot holes for multiple post accessories are not level.
Select a drill and 5/16" drill bit that are appropriate for the wall
material you will be drilling through.
Carefully drill a 5/16" hole at all marked pilot hole locations.
1042441-2-C
Multiple-Post Accessory
Center-to-Center Points
Level
4 Kohler Co.