Adjusting The Level Of The Effect Speakers; Memory Back-Up - Yamaha RX-V1300RDS Manual De Instrucciones

ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS

You can adjust the output level of each effect speaker
(center, left and right rear and subwoofer) while listening
to a music source.
Adjustment should be made with the remote control.
TRANSMIT RE–NAME CLEAR LEARN
SYSTEM
POWER STANDBY SLEEP 6CH INPUT
A PHONO TUNER CD
V-AUX CBL/SAT MD/TAPE CD-R
D-TV/LD VCR 1 VCR2/DVR DVD
SELECT
POWER POWER AMP
1
TV AV
REC
1
Press AMP to select the
AMP mode.
2
Press LEVEL repeatedly to select the
speaker(s) you want to adjust.
Each time you press LEVEL, the selected speaker
changes and appears on the front panel display and
on the video monitor as follows: center, right rear,
rear center, left rear and subwoofer.
LEVEL
TITLE
TV INPUT
y
• Once you press LEVEL, you can also select the speaker(s) to
be adjusted by pressing d / u.
0109V1300_56-68_EN-GB.p65
REC
AUDIO
+
DISC SKIP
VOL
–
2
LEVEL SET MENU MUTE
+
TITLE MENU
TV VOL
TV INPUT A/B/C/D/E
CH CH
TV MUTE
– +
SELECT
PRESET PRESET
TEST ON SCREEN STEREO
TV VOL
RETURN – DISPLAY
3
EFFECT
AMP
Center speaker output level
Right rear speaker output
level
Rear center speaker output
level
Left rear speaker output
level
Subwoofer output level
67
3
Press j / i to adjust the speaker output level.
• The control range for the center or left and right
rear speakers is from +10 dB to –10 dB.
• The control range for the subwoofer is from 0 dB
to –20 dB.
+
TV VOL
CH
TV MUTE
–
SELECT
PRESET
TV VOL
–
Notes
• When the speaker output modes for "1A CENTER SP" and
"1C REAR L/R SP" are set to NONE, and "1E LFE/BASS
OUT" to MAIN, the output level of those speakers cannot be
adjusted because there is no sound coming from these speakers.
• When you adjust the output level with LEVEL, the settings you
made with the test tone will be changed.
• It is recommended to adjust the speakers (except for a
subwoofer) by following the steps described in Using the Test
Tone on pages 24, 25.

Memory back-up

The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby
mode. However if the power cord is disconnected from
the AC outlet, or the power supply is cut for more than
one week, the stored data will be lost. If so, set the
output level again.
2002.11.07, 12:09
CH
+
PRESET
67