Installation Steps; Care And Cleaning - MacNeil WeatherTech WTBF119 Instrucciones De Instalación

Installation Steps

Remove the corresponding fasteners from the rubber trim piece. This is necesary in order for the hood shield flanges to slide under the
rubber trim piece. NOTE: It may be necessary to remove additional fasteners in order to accomodate the flange, depending on size.
3
Position the hood shield with the flanges sliding between the hood
and rubber seal. Align holes.
4
Insert (6) screws through rubber trim and into recep-
tacles and apply pressure while tightening screw to
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
© 2016 by MacNeil IP LLC
NOTE: Actual application may vary slightly from illustrations.
secure to hood.
hood shield
receptacle
screw
Insert (6) receptacles UNDER rubber trim and through
5
Lower hood, adjust hood bumper stops to ensure
hood shield clears grille and headlights. Install bump
ons at pre-cleaned locations on the painted hood/
rubber
trim
7
Page 2 of 2
front edge of
fastener
rubber trim
hood shield, and then into hood.
receptacle
fender surface.
hood
hood shield
rubber trim