Installation Steps; Care And Cleaning - MacNeil WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

Expose 2" (5 cm) of tape liner from each end
of the flanges on the hood shield.
3
Remove remainder of tape liners. Apply strong
pressure at all contact points for proper adhesion.
5
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
© 2011 by MacNeil IP LLC
NOTE: Actual application may vary slightly from illustrations.
Close hood.
Center part on front edge of hood. If necessary
slide flanges under rubber trim.
4
Secure with (4) self tapping screws through
hood shield into sheet metal. NOTE: Toyota
Camry and Pontiac Sunfire have only (2)
6
NOTE: DO NOT OVER TIGHTEN
Apply bump ons to surface of hood.
8
8
7
Page 2 of 2
screw mounting locations.
Bump-on
hood
washer
screw
hood shield