Installation Steps - MacNeil WeatherTech Easy-On Stone & Bug Deflectors Instrucciones De Instalación

Installation Steps

Expose 2" (5 cm) of tape liner from each end of the center flanges
on the hood shield. Ensure that free ends of tape liner are acces-
Free end
3
5
Lightly close hood and check that hood shield is centered properly on hood. Adjust as needed. Raise hood and fully tighten both
6
Check position of hood shield. NOTE: (1) Ensure that center flange where tape will adhere is still centered, and (2) inspect shield to
7
NOTE: Actual application may vary slightly from illustrations.
sible.
Free end
Install (1) fastener in each flange. Do not fully tighten at this time.
X2
fasteners. After tightening, fully close hood.
ensure it is sitting flush on the hood / nose piece.
Position hood shield in place on hood. Align holes in hood shield
flanges with holes in hood.
4
Page 2 of 3
hood
hood shield
fastener