miniland baby humitouch pure Manual Del Usuario página 15

ENGLISH
(H, or I on the remote control) to power it on. The screen located above the button will
light up more brightly. Never power it on when the water tank is empty.
NOTE: The screen will dim after ten seconds for better rest at night. However, the
humidifier continues to function. The screen can be undimmed at any point by simply
pushing any button.
5.3. NIGHTLIGHT/OZONATOR
Push the button for the ozonator/nightlight (J, or III on the remote control) several
times to activate/deactivate the ozone mode and to power on/off the blue nightlight
according to the following:
1st push: the ozone mode is activated and the nightlight comes on.
2nd push: the ozone mode continues to be activated and the nightlight switches off.
3rd push: the ozone mode is deactivated and the nightlight comes on.
4th push: both the ozone mode and the nightlight switch off. Initial position.
5.4. ADJUSTMENT OF THE TIMER
In order to program the automatic powering down of the unit, push the button to adjust
the timer (L, or V on the remote control). The symbol '- -' will appear on the screen
(C), indicating that no operational time has yet been set. Keep pushing the button
(L, or V on the remote control) to select the timer between one and twelve hours. In
order to set the desired operational time, wait for the time value to stop flashing. The
humidifier is thus programmed to turn itself off after the number of hours on the screen
has passed.
5.5. ADJUSTMENT OF THE % OF RELATIVE HUMIDITY
Push the button (K, or IV on the remote control) to activate the adjustment of the
relative humidity. Pushing this button allows you to adjust the desired % of Relative
Humidity (RH) or increase it if you so wish. We recommend a relative humidity between
45% and 60%. The device can be set between 45% and 75% relative humidity or to
Continuous Operation mode (Co).
In order to enter the desired humidity, push the button (K, or IV on the remote control)
several times until you reach the humidity level that you wish to set. In the beginning, it
goes from 'Co' to 45% RH and from this value up to 75% RH, increasing in steps of 5%
RH each time the button is pushed. Once 75% RH is reached, it will return to 'Co' if we
push the button again. In order to set the desired humidity, wait for the humidity value to
stop flashing. The humidifier will thus remain programmed to maintain the room at the
humidity level displayed and will show the indicator on the screen (G).
NOTE: If the humidity of the room is above the set level, the humidifier enters a rest
state. If the humidity of the room is below the set level, the humidifier automatically
activates.
5.6. ADJUSTMENT OF VAPOUR RELEASE
Push the button to adjust the vapour release (I, or II on the remote control) several
times in order to change the desired flow of vapour.
There are three levels of vapour: low, medium, and high. For nocturnal use, we
recommend the low level.
5.7. EMPTY WATER TANK INDICATOR
When the water tank is empty, a symbol will be shown on the screen to warn about it
(F). The humidifier will automatically power itself off. The user must refill the water tank
when the warning signal is displayed.
15