3.
Installing the Detector
1) Fix the angle bar to the base by pushing the bar into the hole
on the base.
2) Align the groove on the T1 with the hook on the angle bar.
3) Hook the T1 to the angle bar and push down the T1 to secure
it.
4) Adjust the detection angle as desired.
4.
Testing (Optional)
You can test the detection angle after the installation.
Hold down the Setting Button on the back of T1 for 3 seconds
to switch T1 to the Testing mode. Walk in the detection area to
trigger the alarm.
T1 automatically returns to the normal mode after 2 minutes.
See page 46-50 for maintenance and appedix information.
7
1
2