Backup - Nice MG3000 Manual Completo

NOTE: To use this function, we suggest the purchase of a TERMINAL BLOCK
MODULE.
The internal relay contained in the TERMINAL BLOCK MODULE is intended for
integration with monitored alarm panels. EXAMPLE:
*Event report generated through a PC with the Guarita IP Software.

10.7 BACKUP

The "Backup" function is used to copy the information stored in the "Internal Me-
mory" of the MG3000 to a flash drive. After making the copy, the flash drive
will have stored all the MG3000's programming, including configurations, event
reports and registered devices. This data will be stored in the flash drive and
identified by date, time and the label configured in the option "SUPPORT".
To perform the backup, with the flash drive connected to the MG3000, in the
basic menu, select the option "BACKUP", then press "Confirm?". Wait until the
device, event, configuration and biometrics records are copied. This process may
take a few minutes depending on the amount of information stored.
If the space on the flash drive is insufficient for storage of the backup, a failure
message will be displayed. In this case, remove the flash drive, free up space
on the device or replace it with another one with available space and redo the
backup procedure. A full backup of registered events and devices will be done
automatically every 8192 events occurred on the internal SD Card, or only de-
vices will also be backed up automatically, whenever the data in a register is
changed and the receivers are updated. NOTE: Use flash drive formatting FAT16
or FAT32.
- ENGLISH -
39
242