before placing the belt over the child's chest.
WARNING! Ensure the belt is not twisted.
5. STRAPPING THE CHILD INTO THE
CHILD SEAT
This child restraint system has a loading position
making it easy to place the child in the seat and
adjust the straps to fit correctly.
4a. Loosen the harness by pressing the button(10)
and pulling the diagonal part of the
harness straps. Unfasten the buckle (5) by pressing
the red button. Move the ends of the buckle to each
side of the seat so you can put the child in the seat.
4b.
Position the child in the seat and place the strap
over him on the both sides, and then fasten the
buckle.
To adjust the headrest(1)pull the level (7)on the top.
It should be set to the right position, this means that
the shoulder harness should come out approximately
1 cm above the child's shoulders.
Tighten harness by pulling the lower strap A(11), it
should fit the child snugly.
4c.
Once the child is securely strapped in,you can
tilt the seat by pressing the lever (12) to the required
position.
To get the child out of the seat,follow the same
process in reverse (4b).
Please make sure that the child gets out of the
vehicle on the pavement side.
EN
33