Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
5
Installing the motor assembly
□
Remove two of the four screws (located diagonally from
each other) (NN) from the top of the mounting plate (A) and
loosen the other two screws (NN).
□
Align the two key slots in the top of the fan motor assembly
(C) with the two loosened screws (NN) on the mounting
plate (A). Push the fan motor assembly (C) up and turn it
clockwise to lock in the mounting plate (A). Tighten the two
screws.
□
Install the two screws that were removed at the beginning
of this step into the remaining two holes and tighten the
four screws firmly.
□
Install the trim ring (B) by aligning the ring's slots with the
screws on the mounting plate (A). Rotate the ring clockwise
to lock in place.
Assembly - Attaching the Fan Blade
1
Attaching the blades to the motor
NOTE: Blade installation must be properly completed before
attaching the light kit.
□
Attach a blade (D) to the fan motor assembly (C) by inserting
the blade (D) into the slot in the side of the fan motor assembly
(C) until it stops. The locking clip will click twice when the
blade is correctly installed. Ensure the blade is snapped into
locking clip (LL) completely by pulling the fan blade away from
the motor housing.
□
Repeat these steps for the remaining blades (D).
Removing the blades
NOTE: If you need to remove the blades, follow the steps below.
NOTE: Make sure you have turned the black plate with notch
towards the blade you would like to remove.
□
Pull the blade locking pin down and turn to the right. Make sure
the pin is engaged with the black slot properly.
□
To remove the blade (D) from the fan motor assembly (C),
squeeze the tab of the locking clip towards the direction of the
blades and pull the fan blade away from the motor housing (C).
□
Repeat these steps for the remaining blades (D).
A
Pin
9
Please contact 1-855-HD-HAMPTON for further assistance.
C
D
LL
Pin
Clip
HAMPTONBAY.COM
NN
B
C
Publicidad
