To Start The Engine; To Stop The Product - RedMax SRTZ235 Manual De Usuario

CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
Product overview on page 2 .
refer to

To start the engine

1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Move the choke lever to the choke position.
WARNING:
to move immediately when you start the
engine with the choke.
3. Hold the body of the product on the ground with your
left hand.
10
Make sure that there is
The cutting unit starts
4. Hold the starter rope handle with your right hand and
the throttle trigger and throttle trigger lockout with
your left hand.
5. Slowly pull out the starter rope with your right hand
until you feel some resistance.
WARNING:
rope around your hand.
6. Pull the cord quickly and with force. Pull a maximum
of 5 times.
CAUTION:
rope to full extension and do not let go of
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
7. Reset the choke when the engine fires.
8. Pull the starter rope again and again until the engine
starts.
9. Operate the throttle gradually when the engine
starts.
10. Make sure that the engine runs smoothly and let the
engine become warm for 1-2 minutes before
operation.

To stop the product

• Push the stop switch to stop the engine.
Do not twist the starter
Do not pull the starter
1695 - 001 - 24.06.2021