To Set The Product In Transport Position; Maintenance; Maintenance Schedule - RedMax SRTZ235 Manual De Usuario

4. Tilt the cutting unit to the applicable position.
5. Adjust the screw to set the friction.
6. Set the cutting unit in different positions to try the
friction.

To set the product in transport position

WARNING:
when the product is in transport position.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.

Maintenance schedule

Maintenance

Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri-
cant.
Make sure that the cutting unit does not move at idle speed.
Do a check of the stop switch.
Examine the cutting unit for damages and cracks. Replace if it is damaged.
Do a check of the throttle trigger lockout and the throttle trigger.
Examine the engine, the fuel tank and the fuel lines for leaks.
Tighten nuts and screws.
12
Do not start the product
Maintenance
Read and understand the
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting unit.
3. Pull down the position adjustment handle.
4. Fold the cutting unit to make it parallel to the shaft.
Daily Weekly Monthly
After each operation.
After each operation.
X
X
X
X
X
X
1695 - 001 - 24.06.2021