To Operate The Product; To Adjust The Angle Of The Cutting Unit; To Adjust The Friction For Angle Adjustment - RedMax SRTZ235 Manual De Usuario

WARNING:
automatically goes back to start position. To
prevent accidental start, remove the spark
plug cap from the spark plug when you
assemble or do maintenance on the product.

To operate the product

• Start near the ground and move the product up
along the hedge when you cut the sides.
• Make sure that the engine does not touch the hedge.
• Hold the product near your body for a stable work
position.
• Make sure that the cutting unit does not touch the
ground.
• Be careful and work slowly until all the branches are
correctly cut.

To adjust the angle of the cutting unit

The cutting unit can be adjusted in 10 different positions.
WARNING:
unit when you adjust the angle.
1. Let the engine run at idle speed and make sure the
cutting unit does not move.
1695 - 001 - 24.06.2021
The stop switch
Do not operate the cutting
2. Pull down the position adjustment handle.
3. Tilt the cutting unit to the correct position. Use 1 of
the procedures that follow.
a) Use the handle.
b) Push the end of the cutting unit against a stable
surface.
4. Release the position adjustment handle to lock the
cutting unit.
5. Push the cutting unit against the hedge to make sure
that it is locked.

To adjust the friction for angle adjustment

WARNING:
unit when you adjust the friction.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting unit
3. Pull down the position adjustment handle.
Do not operate the cutting
11