Cleaning And Maintenance - Mobicool FR 35 AC/DC Instrucciones De Uso

Cleaning and maintenance

7 Cleaning and maintenance
!
WARNING!
Always disconnect the device from the power supply before you
clean and service it.
A
NOTICE! Risk of damage
 Never clean the cooler under running water or in dish water.
 Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
8 Troubleshooting
Fault
Device does not
function, LED does
not glow.
The device does not
cool (plug is inserted,
"POWER" LED is lit).
The device does not
cool (plug is inserted,
"POWER" LED
flashes orange, dis-
play is switched off).
16
Possible cause
There is no voltage
present in the 12/24 V
socket in your vehicle.
Defective compressor. This can only be repaired by an
Battery voltage is too
low.
Suggested remedy
In most vehicles the ignition must be
turned on before power will be sup-
plied to the DC power outlet.
authorised customer services unit.
Test the battery and charge it as
needed.
FR35 AC/DC
EN