Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
W
ATCHING TV
CHANNEL SELECTION
You can select the channel by using either [CH K / L ]
or Channel number buttons. How to select the
channel in each way is shown below.
POWER
1
1
4
4
7
7
-
-
SETUP
BACK
VOL.
1
Using [CH K / L ], or Channel number buttons
and pressing [ENTER].
• Using [CH K / L ], change the channel.
• When you select a channel, press the channel
number you want to view with Channel number
buttons. The selected channel will be displayed.
• When selecting analog channel 12
1
2
ENTER
• When selecting digital channel 12-1
Be sure to press [–] before entering the
minor-channel number.
1
2
-
• If the channel broadcasts NTSC and ATSC both
and you don't press [–], then you will receive the
NTSC channel only. The moment you press [–],
the smallest memorized digital channel will be
displayed.
• When you press [CH RETURN], the previously
selected channel will be selected.
• Same operation is available with [CHANNEL
K / L ] on the front panel of the main unit.
NOTE:
In the DTV broadcasting, one channel sometimes broadcasts
multiple programs depending on the air time. In this case, the
main channel is called major channel and the minor-channel
is called minor channel.
About minor-channel broadcasting:
There may be different programs being broad-
cast on minor-channels through a single chan-
nel from ATSC. You can watch each minor-
channel program being broadcast by selecting
one of the minor-channels.
18
EN
INPUT
SLEEP
SELECT
2
2
3
3
5
5
6
6
AUDIO
8
8
9
9
STILL
0
0
SCREEN
MODE
ENTER
ENTER
INFO
CH RETURN
CH RETURN
CH
CH
MUTE
MUTE
1
ENTER
NTSC
18:00
18:30
CH4
19:00
19:30
20:00
: changes automatically
: change manually by pressing [CH
on your remote control.
NOTE:
"No signal" will appear on the screen after the minor-
channel broadcast is over.
You will need to change the channel to continue
watching another TV program.
VOLUME ADJUSTMENT
This section describes how to adjust the volume
when viewing TV. The Mute function, which is use-
ful when you have a visitor or a phone call, will be
also described.
BACK
CH RETURN
VOL.
VOL.
1
Using [VOL. X / Y ] or [MUTE]
[VOL. X / Y ]
• You can adjust the audio volume with [VOL. X / Y ].
• The volume bar is displayed at the bottom of
the screen when adjusting the volume.
• Same operation is available with [VOLUME
X / Y ] on the front panel of the main unit.
Volume
20
• The volume bar display will automatically dis-
appear in a few seconds.
[MUTE]
• Press [MUTE] on the remote control to mute
the sound.
• To release the Mute status, press [MUTE]
again or press [VOL. X / Y ].
Mute
• "Mute" is displayed on the screen for a few sec-
onds.
ATSC
CH4-1
No signal No signal
CH4-1
CH4-2
CH4-3
CH4-1
No signal
CH4-3
CH4-1
CH4-2
No signal
/ ]
INFO
CH
MUTE
MUTE
Publicidad
Capítulos
Tabla de contenido
