Care And Cleaning - Klarstein CASTILLO Manual Del Usuario

• The first switch turns on the fire flame simulation effect.
• The second switch from the left turns on the heater at 925 watts. The third one turns
the heater on at 925 watts. If both switches are ON, the heater is on at 1850 watts.
• The fourth switch count from left turns on the fan only without heating function.
• The knob on the left adjusts the fire effect intensity. Turn this one to get the desired
fire look.
• The knob on the right is the thermostat that automatically turns the heater on and off
to maintain a constant temperature. Turn the thermostat switch clockwise increase
the desired temperature and anti-clockwise to lower it.
Note: Fan function is necessary to activate heat functions. Without fan the heating can
not run.
Notes on Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g.
due to blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect to the mains supply and switch on the appliance.

CARE AND CLEANING

• Before cleaning the appliance, disconnect it from the socket and leave to cool off.
• You can clean the exterior surface of the heater with a soft, damp cloth.
• Do not use cleaning or polishing products.
Note: This product does not use a standard bulb for its flame effect. The appliance
uses an electronically controlled LED system to create the effect, therefor no parts
need to be replaced. There are no user-serviceable parts on this appliance. Under
no circumstances should the appliance be serviced be anyone other than a qualified
electrician.
EN
13