Elvox 7200 Serie Instrucciones De Funcionamiento página 6

Front panel commands and controls
A) 7" TFT LCD colour screen, 16:9 aspect ratio
B) Microphone
C) Loudspeaker
D) Pair of push-buttons "
vation of auxiliary functions or intercom calls and for contrast
control (when display is switched on), conversation volume and
ringtone volume (when display is switched off).
E) Pair of push-buttons "
activation of auxiliary functions or intercom calls and for bri-
ghtness control (when display is switched on) and melody
selection (when display is switched off).
F) Push-button
the speech unit camera or a standalone camera (programmed
on the entrance panel) and/or to enter setting mode.
G) Push-button
actuator type 69RH (e.g. stair lights).
H) Push-button
I) Talk/listen push-button: to communicate with the
speech unit on receiving a call or after self-start or to communi-
cate with intercom devices. The default conversation mode is
"HANDS FREE". Alternatively the unit can be set to push-to-talk
mode (see paragraph "Communication mode selection fun-
ction").
" and "
" and "
: for monitor self-start on activation of
: for auxiliary service, 1st relay of 1st
: for door lock release.
E N G L I S H
L) Ringtone mute indicator: if the red LED lights up, this
indicates that the call tone is off. The red LED also remains on
throughout the conversation, e.g. as long as the audio connec-
tion is active.
": for acti-
M) Door open indicator: if the green LED lights up, this
indicates that the door is open (this function is optional depen-
ding on the type of installation). If the green LED is flashing,
this also indicates setting mode, enabling the brightness, con-
tract, volume or melody to be adjusted using the arrow buttons
": for
"
SETTINGS
Ringtone volume and melody selection functions
These settings can be adjusted with the display switched off.
Press push-button
the green LED
normally used to indicate DOOR OPEN. This flashing indicates
"SETTING" mode, during which buttons
can be used to adjust the ringtone volume and push-buttons
and
The monitor will remain in "SETTING" mode (green LED fla-
shing) until the arrow buttons are pressed.
, , " and "
(self-start) for 2 seconds, until
at the bottom right flashes. This LED is
to select the melody.
".
and