Elvox 7200 Serie Instrucciones De Funcionamiento página 7

SETTING mode is cancelled when the arrow buttons are not
pressed for more than 5 seconds. Nevertheless the user can exit
this mode by pressing button
LED switches off.
Ringtone mute function
Ringtone mute is activated using the same procedure described
above for adjusting the ringtone volume. Once the volume has
been adjusted to the lowest setting by repeatedly pressing the
down arrow, the red LED
illuminates to indicate that ringtone mute is activated.
Brightness and contrast control functions
These settings can be adjusted with the display switched on.
Press push-button
green LED at the bottom left flashes.
This LED normally serves as the OPEN DOOR indicator. This
flashing indicates entry into "SETTING" mode, during which but-
tons and
buttons and
the maximum and minimum values are reached, this is indicated
by a beep. The monitor will remain in "SETTING" mode (green
LED flashing) until the arrow buttons are pressed.
SETTING mode is cancelled when the arrow buttons are not
pressed for more than 5 seconds. Nevertheless the user can exit
this mode by pressing button
LED switches off.
again until the green
in the bottom left-hand corner
(self-start) for 2 seconds, until the
can be used to set the contrast and
to select the brightness. When
again until the green
E N G L I S H
Communication mode selection function (
It is possible to choose between two different modes of commu-
nication with speech units or intercom devices:
1. HANDS FREE mode: press the TALK/LISTEN push-button
at the start of the conversation only, to activate the
audio, and at the end of the conversation to deactivate the
audio. The "audio active" condition is indicated by the illumi-
nation of the red LED
monitor, which is normally used to indicate RINGTONE
MUTE.
2. PUSH-TO-TALK mode: keep the talk/listen push-button
pressed during the conversation; release it at the
end of the conversation.
The 7200 series monitor is factory set to HANDS FREE commu-
nication mode. To switch from one mode to the other, with the
monitor switched OFF press push-button
seconds to enter SETTING mode; simultaneously press and
hold down push-buttons
underneath starts flashing. At this point, while the LED is
flashing, press the TALK/LISTEN push-button
firm the change. The function is confirmed if the red LED swit-
ches off.
button)
at the bottom left corner of the
and until the red LED
. to con-
for 2