Acuity Brands Lithonia Lighting LBR468 FPAN Instrucciones De Instalación

•
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and
other hazards please read all warnings and instructions included with and on the fixture box and all fixture labels.
•
Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
•
Installation and service of luminaires should be performed by a qualified licensed electrician.
•
Maintenance of the luminaires should be performed by person(s) familiar with the luminaires' construction and operation
and any hazards involved. Regular fixture maintenance programs are recommended.
•
It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on ambient
dirt level and minimum light output which is acceptable to user. Refractor/lens should be washed in a solution of warm
water and any mild, non-abrasive household detergent, rinsed with clean water and wiped dry. Should optical assembly
become dirty on the inside, wipe refractor/lens and clean in above manner, replacing damaged gaskets as necessary.
•
DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have been
damaged during transit. Inspect to confirm. Any part damaged or broken during or after assembly should be replaced.
•
Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov.
•
These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency
to meet in connection with installation, operation, or maintenance. Should further information be desired or should
particular problems arise which are not covered sufficiently for the purchaser's or owner's purposes, this matter should be
referred to Acuity Brands Lighting, Inc.
RISK OF ELECTRIC SHOCK
✓ Disconnect or turn off power before
installation or servicing.
✓ Verify that supply voltage is correct by
comparing it with the luminaire label
information.
✓ Make all electrical and grounded
connections in accordance with the National
Electrical Code (NEC) and any applicable
local code requirements.
✓ All wiring connections should be capped
with UL approved recognized wire
connectors.
RISK OF INJURY
✓ Wear gloves and safety glasses at all times
when removing luminaire from carton,
installing, servicing or performing
maintenance.
✓ Avoid direct eye exposure to the light source
while it is on.
WARNING
CAUTION
Lithonia Lighting
1400 Lester Road Conyers Georgia 30012
P 800 315 4982 F 770 860 3129
www.Lithonia.com
WARNING
RISK OF BURN
✓ Allow lamp/fixture to cool before handling.
Do not touch enclosure or light source.
✓ Do not exceed maximum wattage marked on
luminaire label.
✓ Follow all manufacturer's warnings,
recommendations and restrictions for: driver
type, burning position, mounting
locations/methods, replacement and
recycling.
CAUTION
RISK OF FIRE
✓ Keep combustible and other materials that
can burn, away from lamp/lens.
✓ Do not operate in close proximity to persons,
combustible materials or substances
affected by heat or drying.
912-00158-001 Rev. B
Page 1
© Acuity Brands Lighting, Inc. 2015
All Rights Reserved
.